Thingiverse
Can dispenser
von VLS1990
72
Downloads
68
Likes
0
Makes
Printed with a mix of PLA and PETG as I was running out of filament.
Design with -0.2mm clearances, If your printer is accurate it does not need horizontal expansion
Designed taking into consideration a 33CL coca cola can
20% infill 0.25mm layer height
Assemble A1 wit A2, B1 with B2 and so on, after you can put everything together and Voila! :)
You will need the face on the printplate I am afraid... Sorry...
19/11 Added version V2
Smaller top shelf to make easier to take out the last cans
Design with -0.2mm clearances, If your printer is accurate it does not need horizontal expansion
Designed taking into consideration a 33CL coca cola can
20% infill 0.25mm layer height
Assemble A1 wit A2, B1 with B2 and so on, after you can put everything together and Voila! :)
You will need the face on the printplate I am afraid... Sorry...
19/11 Added version V2
Smaller top shelf to make easier to take out the last cans
VLS1990 veröffentlicht auch auf
11 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
