Thingiverse
Can Holder / Handle
by 999henry
1.8k
Downloads
5.1k
Likes
16
Makes
Does print without support.
Sleek can just added.
Please support me on MakerWorld! Thank you! https://makerworld.com/en/models/379314#profileId-279402
It's designed for the 12oz can which has a diameter of 2.6'' or 6.6 cm.
The cut-out was added so that your mouth wouldn't touch it while drinking, and save material of course.
The thumb area had a modifier without the top layer so it could have a surface with more friction.
The hole at the bottom was added so you can push the can out.
Update 7/12: I added a sleek can version. I didn't have a can when I designed it, so the size is a bit too tight but still works.
Sleek can just added.
Please support me on MakerWorld! Thank you! https://makerworld.com/en/models/379314#profileId-279402
It's designed for the 12oz can which has a diameter of 2.6'' or 6.6 cm.
The cut-out was added so that your mouth wouldn't touch it while drinking, and save material of course.
The thumb area had a modifier without the top layer so it could have a surface with more friction.
The hole at the bottom was added so you can push the can out.
Update 7/12: I added a sleek can version. I didn't have a can when I designed it, so the size is a bit too tight but still works.
999henry also publishes on
8 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
