Thingiverse
Can Rotator
por 3d_Kay
143
Descargas
124
Likes
1
Makes
Just a can rotator. It should fit 6 standard sized cans (15oz).
You will need to mirror the serpentine side and print 3 flat braces and 2 square braces.
I would adhere the braces to the sides so it is solid.
These were designed in Fusion 360.
If you have any suggestions on any part of this I would love to hear them.
12/28/18 - I added some different size braces, for 12oz soda cans and 16oz beer cans.
NOTE: I have not tested these size of cans and they are different shapes than a regular food can, so as of now I am not sure they will roll
You will need to mirror the serpentine side and print 3 flat braces and 2 square braces.
I would adhere the braces to the sides so it is solid.
These were designed in Fusion 360.
If you have any suggestions on any part of this I would love to hear them.
12/28/18 - I added some different size braces, for 12oz soda cans and 16oz beer cans.
NOTE: I have not tested these size of cans and they are different shapes than a regular food can, so as of now I am not sure they will roll
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
