CanaKit mount for under Lack

I finally moved my PSU out of my enclosure and decided to remove my OctoPi outside instead. I wanted it just below the table and next to the leg and the other designs out there didn't seem to find my needs.



This is designed to screw in underneath the table.

The CanaKit case has two slots on the back that will slide over the nubs and lock in.

In case the nubs break off, I designed two divots on the back to drill through in case you would rather replace the nubs with a small screw.



I printed in PETG and it was very risky removing the supports without tearing off the nubs as well. Maybe you'll have better luck or other materials may work better.



I have no preferences for infill, but you'll probably need support.

I designed the model upright as if it were installed, which doesn't play so well when slicing. I HIGHLY Suggest placing the top face with screw holes against the bed to reduce the amount of support material and also for better adhesion.