Thingiverse
Candle Cutter
von Jordaan_Labs
0
Downloads
1
Likes
0
Makes
Cuts a candle normal 20 diameter to fit into a candle holder.
Preferably print both
Candle goes in where the inside (teeth flush) is flat , turn the cutter while pushing the candle deeper to cut it.
Use the 30 degree to begin the cut (less teeth one)
And finish it with the 60 degree
Preferably print both
Candle goes in where the inside (teeth flush) is flat , turn the cutter while pushing the candle deeper to cut it.
Use the 30 degree to begin the cut (less teeth one)
And finish it with the 60 degree
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
