Slicer Discord
Canister Aquarium Filter – 3D-Druckmodell von Thingiverse Thingiverse

Canister Aquarium Filter

66 Downloads
75 Likes
0 Makes
Zum Modell
Canister Filter for your small Aquarium for less than £15

1 x clip lock container from pound land 1.4 litre £1

1 x 12 v DC submersible pump from Amazon £9

A good length of aquarium tubing I am using 8mm as it fits the pump Ebay £3.00

Any media lying around that you have spare

You tube video

https://www.youtube.com/watch?v=cd2AxTlKykc&t=211s

I have added a top media retainer only because I could

Filter media of your choice, I use a coarse pad on the bottom media balls and activated charcoal bag in the centre and a fine floss at the top

I am going to use this on my 2FT 60cm Shellie Tank as the Fluval 2+ in there is not man enough to cope I am also trying out a sponge biological filter in there as well

Print off top and bottom retainers
.3 Resolution
20% infill

Updated Bottom Retainer so the tube diameter fits snugly pushed into tube

Print short top tube
.3 Resolution
100 % infill
Adhesion setting to ensure stick ability to bed as tube is thin
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

simonlewis962 veröffentlicht auch auf

3 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen