Slicer Discord
Cannon Battle Game – 3D-Druckmodell von MakerWorld MakerWorld
Board Games

Cannon Battle Game

1 Downloads
4 Likes
0 Makes
Zum Modell
This is one of my best models so far! It is a game where you shoot cannonballs at your opponent's boats and try to sink them all! The rules are simple: players take turns shooting cannons and can switch out their cannon or cannon base at any time (only with the advanced set). Instead of firing a cannon, players can choose to move any boat around the water, either putting their own boats in a more difficult place for their opponent to hit or moving the other boats closer to the center to make it easier to sink. The game is played in a container (200x200mm minimum) filled with water, or the printed container that will be added soon. Start the game by placing all the boats with one sailor in the middle of each boat near the center of the container. if the sailor is knocked off the boat or the boat sinks, the boat is eliminated. If a boat sinks while players are collecting cannonballs at the bottom of the container, you may put it back in the water. The basic set includes a 1mm thickne
Kategorie
Board Games
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
großer Druck
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 2/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
200 mm (Groß)
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen