Canon Grip

How to build grip for Canon 400D.

Required hardware (see PIC001.JPG):
- Glue (CA or Epoxy);
- A couple of rechargeable batteries 18650;
- Container for the batteries;
- Any died AA or AAA battery to make contacts;
- Male and female connectors;
- Nail (1/10" or 2,5 mm diameter). It should fit to small hole in the bottom of the camera body;
- 1/4" screw. If you cannot bye inch thread screw, you can get it from cheap selfie stick.

Steps to build:
1) Print the parts (see PIC002.JPG).
2) Use sandpaper to fit Part 1 and Part 2.
3) Saw off screw and nail (PIC003.JPG). Glue them with Part 3 and Part 4 (PIC004.JPG). Let the glue dry.
4) Remove the battery box cap from the camera body (PIC005.JPG).
5) Fasten Part 1 to body, put Part 4 with nail to the small hole. Align Part 1 along to body
and glue Part 4 by a couple of glue drops (PIC006.JPG).
6) Unfasten Part 1. Put Part 5 into battery cap place (PIC007.JPG), put a couple of glue drops on it.
Fasten Part 1 again.