Thingiverse
Cap for 5mm LED
door M-Things
14
Downloads
8
Likes
0
Makes
Small caps to put on your LED chains, perfect for christmas! Due to the single walled design they should be translucent with almost any filament/color. One cap needs around 13cm of 1,75mm filament.
5mm LEDs shout fit, and if not, just resize it a little tiny bit and print again. +/- 0.1mm
I printed them with 0.4mm nozzle with ABS.
Very fast and easy to print. You should have no problems printing 50+ of them in around 1,5 hours. Just becareful when pulling them off the build plate, they are fragile!
Layer Height: 2-3mm
Perimeters: 1 (single walled!)
Infill: 0%
Top/Bottom Thickness: 0
Raft: No
Support: No
Material: ABS
Use high extrusion temperature for better layer adhesion.
5mm LEDs shout fit, and if not, just resize it a little tiny bit and print again. +/- 0.1mm
I printed them with 0.4mm nozzle with ABS.
Very fast and easy to print. You should have no problems printing 50+ of them in around 1,5 hours. Just becareful when pulling them off the build plate, they are fragile!
Layer Height: 2-3mm
Perimeters: 1 (single walled!)
Infill: 0%
Top/Bottom Thickness: 0
Raft: No
Support: No
Material: ABS
Use high extrusion temperature for better layer adhesion.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
