Thingiverse
Cap for Tupperware rolling pin
von Lars1976
5
Downloads
1
Likes
0
Makes
Cap for rolling pin which can be filled with water. Pretty sure it's Tupperware.
Print gasket in tpu, or reuse an existing one. I used 0.2 layer height. Bottom layer concentric and then three layer with lines. Enable ironing on top layer. Should be pretty watertight.
Print gasket in tpu, or reuse an existing one. I used 0.2 layer height. Bottom layer concentric and then three layer with lines. Enable ironing on top layer. Should be pretty watertight.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!