Slicer Discord
Cap holder for Elitech RC 5 – 3D-printbaar model van MakerWorld MakerWorld
Other Tools

Cap holder for Elitech RC 5

3 Downloads
1 Likes
1 Makes
Model downloaden
In Elitech RC5 dataloggers the cap tab often breaks off, this makes the datalogger much less resistant to water or moisture.Since recreating the cap with the same tab so fine would always expose it to new breakage then I thought I would keep the original cap and hold it in place some other way. If the cap is in the position it needs to be it will properly flush the o-ring embedded in the cap, keeping the datalogger safe from water and moisture.This “shirt” allows the original cap to be reused, does not create an impediment to the use of the DL, and is easy to use, just slip it into the DL from the end closest to the cap.
Categorie
Other Tools
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Beginner Lage betrouwbaarheid
Eendelig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 0/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Min. bedgrootte
50 mm (Klein)
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

6 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie