Thingiverse
Cap Wrench
von GMD_3D
2
Downloads
2
Likes
0
Makes
It's a cap wrench.
It grips when turned to the left and works on the most common cap sizes (27-31mm). I used a #6 washer and screw for the bottle opener, but it can also accept an M3 x 3mm heat set insert and screw for a stronger connection.
The cavity inside will accept a 10x2mm magnet if you so desire.
Please let me know if there are any issues and I will update the model!
Updates:
- Updated lids have tighter snap fits and allow for 2 or 3 magnets inside (one works but is pretty weak)
It grips when turned to the left and works on the most common cap sizes (27-31mm). I used a #6 washer and screw for the bottle opener, but it can also accept an M3 x 3mm heat set insert and screw for a stronger connection.
The cavity inside will accept a 10x2mm magnet if you so desire.
Please let me know if there are any issues and I will update the model!
Updates:
- Updated lids have tighter snap fits and allow for 2 or 3 magnets inside (one works but is pretty weak)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
