Thingiverse
Capacitive 18mm sensor adjustable
por Gamu_Zgz
0
Descargas
1
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://v1.tinkercad.com/things/1P3EKniRi1T
It's inspired in https://www.thingiverse.com/thing:2153030 Right Side 18mm Sensor Anet A8 Stock.
I find difficult to fine adjusting z end so i started from scratch magink gapes to lmove uo por down the whole mount.. I alsa move a litle to the right the holder so i can adjust the nut much better . WHen i try it i'll put the changest to make to the marlin firmware to adjust it.
Still working on it.
It's inspired in https://www.thingiverse.com/thing:2153030 Right Side 18mm Sensor Anet A8 Stock.
I find difficult to fine adjusting z end so i started from scratch magink gapes to lmove uo por down the whole mount.. I alsa move a litle to the right the holder so i can adjust the nut much better . WHen i try it i'll put the changest to make to the marlin firmware to adjust it.
Still working on it.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
