Slicer Discord
Cape May Insert – 3D-Druckmodell von Thingiverse Thingiverse

Cape May Insert

von Patella
21 Downloads
11 Likes
1 Makes
Zum Modell
Cape May Insert. Holds sleeved cards. (It should hold just about any sleeves you throw at it. (I had some super-thick Titan Shields for the large cards, and it holds those, so...) This doesn't work so well as a table organizer, just because it took a little work to get all those minis organized.

A few notes:
* I know that the Landmark Bases are not player specific pieces. They just happen to fit 5 to a player tray, so that's where they went. Obviously share them out as needed during play.
* In the same area as the Landmark Bases, I placed the Prestige Tokens. You can't really see them in any photos and I figured folks might ask.
*The Token spaces in the Victorian Minis tray are NOT the same size. Cottage Tokens go in the two left-most spaces and Shop Tokens go in the two right-most. Make certain the Shop tokens go in with a flat side up/down and "points" to the left/right.
* The Player Markers are a little tight in their area. (That's also where I put the Income Tokens
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen