Thingiverse
Capsela Cap Extension
von VTXRider1
3
Downloads
2
Likes
0
Makes
Allows a wheel and sprocket on the same connector hub or axle.
Made in Tinkercad https://www.tinkercad.com/things/8dg2md9sMAQ
Due to the threads, should be printed 0.12 layer. 5 tops and bottoms and 3 walls for strength.
The stud can be glued to a cap. Due to thread tolerance, these will not stack. Only one will work on a hub.
Made in Tinkercad https://www.tinkercad.com/things/8dg2md9sMAQ
Due to the threads, should be printed 0.12 layer. 5 tops and bottoms and 3 walls for strength.
The stud can be glued to a cap. Due to thread tolerance, these will not stack. Only one will work on a hub.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
