Thingiverse
CAPSULE DOLL SUPPORT
von Anarkia333
4
Downloads
1
Likes
0
Makes
Support capsule for the Doll floor. (WM Dolls/Piper/Starpery....).
Nylon cap to allow a tight fit between the M6/M8 Screw head and the internal diameter of the cap.
Tested by the "Ava Love Doll" Reseller on several Dolls.
Nylon PA12 for Flexibility.
Screw heads are :
-10 mm for a M6 Cylindrical Head Screw
-13 mm for a M8 Cylindrical Head Screw
I put several versions of the inner diameter to receive the Screw so you can adjust the tightening. SLS printing is more accurate than FDM, which gives smaller holes.
If you print with SLS, tested with 9.5 or 9.7mm, if you print at home in FDM tested 10 or 10.3mm.
Nylon cap to allow a tight fit between the M6/M8 Screw head and the internal diameter of the cap.
Tested by the "Ava Love Doll" Reseller on several Dolls.
Nylon PA12 for Flexibility.
Screw heads are :
-10 mm for a M6 Cylindrical Head Screw
-13 mm for a M8 Cylindrical Head Screw
I put several versions of the inner diameter to receive the Screw so you can adjust the tightening. SLS printing is more accurate than FDM, which gives smaller holes.
If you print with SLS, tested with 9.5 or 9.7mm, if you print at home in FDM tested 10 or 10.3mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
