Captain America Shield Keychain

"Avengers……assemble!" I spent a while tweaking this file to make it easiest to print/assemble. Prints in two separate parts; the main shield body & the inner circle / star. The reason I did this was because I didn't like the way the star looked when I had the file combined. So instead I opted to split it, add a little bit of tolerance, and then pop the two parts together. Objects should already be oriented the correct way when you open it in Bambu Studio - the Star that will be on top of the shield should print face down to get the best quality. No supports required. I added dovetails to line everything up and angled them so that you don't need supports. I also added a little arrow on the bottom of the shield main body; this is to make sure the inner part is aligned properly to slide in - just line the top point of the shield with this arrow and the bottom should slide right in. The tolerance that I built in is .25mm - I tried .2 which was too tight and .3 which was too