Car Antler Replacement

I made this because my car antler fell off when I was driving. It got run over by a car and I needed to print a new internal piece. The fabric part was not damaged so this design slips onto the fabric part. This needs to be printed in two separate parts due to the antler length being 18" long. There is a cylindrical cavity that can be used to insert a 4-40 x 1" screw with the head cut off to connect the two pieces. I used super glue as well as the screw but any other piece of metal or material should work. Using only superglue could work as well.Use PETG even though it is weaker than PLA. PETG is tougher.