Car Headrest Hook

Got bags? Not pumped about leaving them on the floor, or perhaps the seat? Yeah, me too. Can't tell you how many times I've forgotten a bag in the car because it was just out of sight. Well, forget no more! My print shown here was done in the brand-new Cookiecad ASA (Dark Magic of course!). You'll want to print this out of something that can take the heat of a hot car in the summer. So, ASA, ABS, PC, PA, maybe PETG, depending on how hot it is where you are. Or maybe that new HT-PLA that Polymaker's got. The profile's setup for Polymaker ASA, but the settings are generic enough that you'll be fine swapping in Bambu ASA or most anything else. There's a very small amount of support necessary here. For me, it pops right off, interface layer and all. Prints with 6 walls for lots of strength. Remember gang, if you want strength, you want walls. Higher infill percentages have a quickly diminishing return on the plastic you just invested. Looking to do any mods to t