MakerWorld
Vehicles
Model downloaden
Car Plastic Underbelly Rivet
665
Downloads
329
Likes
226
Makes
This is a rivet designed to hold the plastic underbelly of a car up to the chassis, much like the black store-bought version (shown in the cover photo). It was designed with the 2003-2008 Toyota Corolla in mind, but can likely be used on the vast majority of vehicles. I highly recommend that PLA is NOT used to print this, as the heat radiated from roads in most areas can be enough to at least deform it. A good recommendation for filaments:PETG (any)Anything else with a heat resistance above 69 degrees Celsius
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!