Car Sim Ignition Panel | Wiring Box / Button Box

Description: This is a 3D printed car simulator ignition switch panel wiring box. It can be used to put all your wiring into it, or you can print the version with holes for buttons. It is easy to print, no supports needed for both versions. How to use: The print has two parts. The box and the lid. The lid has 4 screw holes at the corners, so just print, secure the ignition panel with screws, and stick the power wire through the hole in the middle of the lid. Then screw the lid on, and you are ready to drive! This design was not entirely by me. It is largely based off of Palli97's “Button Box”. You can find that HERE. I made it so that you could print it without supports, and made the no-buttons version. I also made it stronger in design with fillets, and aesthetically pleasing. All credits go fully to Palli97. All parts were remixed by me in Onshape.