Thingiverse
Car trash bin for bottelholder
door maxmade_3d
34
Downloads
36
Likes
0
Makes
Hey,
this is a car bin for trash. it fits in normal bottel holder holes with a Diameter grater then 65mm.
I will youse a kabel wire for the hinge but you can also try to print the bolt or use a M3 screw if you heat it up a little bit :D
hope you enjoy and pls post your makes :D
I recommend to use ABS for this print, because 60 degrees or over in the Car could be reached in the sommer-sun
If you like it you can also tip me.
That would make me happy xD
this is a car bin for trash. it fits in normal bottel holder holes with a Diameter grater then 65mm.
I will youse a kabel wire for the hinge but you can also try to print the bolt or use a M3 screw if you heat it up a little bit :D
hope you enjoy and pls post your makes :D
I recommend to use ABS for this print, because 60 degrees or over in the Car could be reached in the sommer-sun
If you like it you can also tip me.
That would make me happy xD
maxmade_3d publiceert ook op
31 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
