Thingiverse
Car Trash Can
von Ettuf
4
Downloads
6
Likes
0
Makes
This is a trash can i made for my car to fit in the cup holder.
Took the measurements from a standard can so there are still some of space around it. (in my car´s cup holder, Tesla Y)
Put a plastic bag in the "Inner part" and put the "Outer part" on to on from the top to hold the bag in place and then put your chosen lid on.
Most wall´s are 1mm thick.
I printed it in PLA but do keep the heat in the car in mind when chooseing the material.
Took the measurements from a standard can so there are still some of space around it. (in my car´s cup holder, Tesla Y)
Put a plastic bag in the "Inner part" and put the "Outer part" on to on from the top to hold the bag in place and then put your chosen lid on.
Most wall´s are 1mm thick.
I printed it in PLA but do keep the heat in the car in mind when chooseing the material.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
