Carabiner Organization System

This is the C.O.S. I was tired of digging around in boxes, bags, and closets to find the correct climbing gear for the day. With this I can organize my quick draws, locking gates, wire gates, and any other gear. Increased width model has 15 holes for gear, loops for a helmet or two, and a hole at the top to hang in the closet. It's a little thicker than the normal width for extra rigidity. Normal width model has the same hole count as the increased width model but is a little skinnier for lighter gear and decreased print time. The circular model is for larger amounts of gear storage. I would suggest making the Z axis (height of the print) about 1/8" - ¼" shorter, just make sure to unlock scaling when doing so. Use at least 25% infill If you plan on leaving this in your car, print with ABS or another high glass transition filament.If you are going to use it for storage and bringing it to the crag, PLA(+) will do just fine. This is not for climbing! Do not use while climbing!