Thingiverse
Carbonation Cap PET bottle
par LightningShark
28
Téléchargements
20
Likes
1
Makes
Carbonation cap for carbonating drinks in a PET bottle
Ball Lock connector fitting.
Put an oring on the top groove. Put a rubber or similar washer inside the cap to seal against the bottle for a better fit.
Seen other models but they didn't seem to work well with my ball lock fitting so measured up my stainless post and replicated it
Thickened up the base near the thread so it doesnt distort when tightened
Ball Lock connector fitting.
Put an oring on the top groove. Put a rubber or similar washer inside the cap to seal against the bottle for a better fit.
Seen other models but they didn't seem to work well with my ball lock fitting so measured up my stainless post and replicated it
Thickened up the base near the thread so it doesnt distort when tightened
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !