Thingiverse
Cargo Strap Holder
von ciphan
22
Downloads
26
Likes
0
Makes
A holder to protect your tie-down straps from spontaneous knotting caused by the scourge of entropy. Designed for 1" (25 mm) straps - could probably work with 1.5" in a pinch, or just scale it up for larger sizes. 2 mm thick for strength and 18.75 mm bolsters to hold the hooks with a 1.2 mm slot at the bottom to keep the straps in place once wrangled. Rounded edges all around to prevent any sharp corners from damaging your straps or your delicate digits.
I had a similar design that was included with an old set of straps and a new set I purchased didn't come with any storage solution so I created this design myself using Fusion 360. I may consider creating a case of sorts that these can slot into for organization of multiple straps and their corresponding ratchets.
I had a similar design that was included with an old set of straps and a new set I purchased didn't come with any storage solution so I created this design myself using Fusion 360. I may consider creating a case of sorts that these can slot into for organization of multiple straps and their corresponding ratchets.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!