Carl the Cube(ish) Cat

Be careful when breaking in the joints, or the joints might literally break. :-)

Carl is a cat that folds into a kind-of-cube-shape, better known as a rectangular prism. He is articulated and print in place.

Printing:

Carl's joints did not print correctly on my Anycubic, but printed fine on my Sovol. I recommend printing the test joint first to make sure your printer can handle it. The model is a little large at 100% (22 cm long) and might not fit on some smaller printer's build plates. I printed it at 70% (only 15 cm long) and it printed with some problems. The joints were slightly fused together, and some connections broke as they were weak. I also think I was using some filament that had absorbed some moisture, so, again, I recommend printing the test joint at whatever size you are trying.

After Printing:

The joints should (and will be) slightly stuck at first. Simply move then in the directions they are meant to move and they should begin working. The overhanging par