Thingiverse
CarProg adapter D1 case
von Diolum
2
Downloads
0
Likes
0
Makes
CarProg adapter D1 Case
with space for relay on one.
Use 2.5 mm screws with head 1.8 mm thick maximum
If port perfectly align everything will close correctly. if not just put a 5mm long piece of filament in the hole on each side to be pushed with the screw to align everything when closed.
in picture cutout for the relay at wrong place. Corrected in the STL
with space for relay on one.
Use 2.5 mm screws with head 1.8 mm thick maximum
If port perfectly align everything will close correctly. if not just put a 5mm long piece of filament in the hole on each side to be pushed with the screw to align everything when closed.
in picture cutout for the relay at wrong place. Corrected in the STL
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
