Carrot Sharpie Cap/Lid

by Jamburgg · Office

68 Downloads

42 Likes

29 Makes

A fun replacement cap/lid for a standard sharpie, it just slides on. Carrot-themed since it's Easter season. It can be used as a replacement cap or fit on the back of the sharpie for a fun little addition. Print Guide:Prints in multiple pieces, one carrot body and three leaves. The leaves can then be inserted and glued into place. Walls/Perimeters: 2 doesn't need to be strong but I don't think one wall would cut itInfill: Any. There is only a small amount of infill so this shouldn't matter too muchSupports: NoneLayer Height: Any. 0.2mm used here but a smaller layer height would make the top surface smoother.Material: Any. PLA used here but any can be usedBrim: Would recommend when printing the carrot as the bed contact area is low.