Thingiverse
Case Collator
di Marcconi
61
Download
23
Likes
0
Makes
Yet another case collator.
I could not find pipes of proper size in Poland, so I decided to make my own design that fits properly with easily available 15mm/13mm plexi pipes.
This is two part design, 2 screws and 2 nuts needed to assembly it.
Bottom of collator dish is slightly sloped to the center which improves operation.
Works excellent with 9mm, 38spec and 357mag brass.
It also works ok with 45acp but filling pipes takes a bit more time.
I could not find pipes of proper size in Poland, so I decided to make my own design that fits properly with easily available 15mm/13mm plexi pipes.
This is two part design, 2 screws and 2 nuts needed to assembly it.
Bottom of collator dish is slightly sloped to the center which improves operation.
Works excellent with 9mm, 38spec and 357mag brass.
It also works ok with 45acp but filling pipes takes a bit more time.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
