Case feeder - 223 plate - fixed

Fixed the .223 plate. Now in four separate STL's and no errors in STL's.

This is now fixed from my old version. I have deleted the old files. The new V3 files work as they are 1% smaller than the old version.

The V3 files have the "joint bumps" smaller and farther back from the outside edge. This stops some issues when more than 30 .223 rounds are loaded into the hopper.

The SCAD_V2.ZIP file contains my "hack" to make this thing.

The 223SplitV3_All.stl file contains the entire disk. It looks like one part but is actually all four parts in one .STL.

So far V3 has been working very well with .223's with STAH's modification to the drop tube. The original drop tube is too small for .223's.

The center hole is a bit small. I recommend printing with 3 shells and then drilling the hold out to fit your motor. I only had to drill it out a very small amount to fit nice and snug on my motor shaft.

NOTE: Added 223_Full_Plate.stl No split or bumps, just the plate.