Case for a 12864 SSD1306 I2C OLED module

This is a small case for a cheap 128x64 sized OLED display module with four pins (I2C interface).

I made this as small as possible. A litte force maybe needed to push the module in. Then put a drop of CA-glue on each of the poles and put on the backside lid and press it down a few seconds. I decided against screws, because they would have to be really small and short.

For soldered headers (straight or angled) there is a backside lid with a notch. For regular wires soldered directly to the PCB, there is a case with a notch on the top side (and a lid with an outside notch at the same position).