Case for Arizer Air MAX

This is a TPU case for an Arizer Air MAX vaporizer. It was printed in non-AMS TPU using the side loader rather than the AMS. It includes a cover for the USB-C port than can also be used as a tamper for your dry herbs. There are 3 different USB-C covers, but you only need 1. The only difference is what's on the underside: the Arizer A, concentric rings, or a flat design. This model can be printed without supports, but if necessary I have put support enforcers where they're needed. If you print without supports, you may just need to clean up the bridge with your favorite sharp blade. You may need to go into your Device > Print Options > Uncheck Enable AI Monitoring of the print, my X1C kept detecting spaghetti about halfway through the print when there wasn't any. Once I turned that off I had 0 issues printing.