Thingiverse
Case for brushless motor controller
von Planetech3D
15
Downloads
8
Likes
1
Makes
Case for a 3/4 wire brushless motor controller card.
This motor driver works very well with hard drive engines.
You will need two M3 screws to close the case
This motor driver works very well with hard drive engines.
You will need two M3 screws to close the case
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
