Thingiverse
Case for Bypass / Switch
0
Downloads
1
Likes
0
Makes
A replacement case for this listing; https://www.etsy.com/listing/1516066706/bypassswitch-for-mono-or-stereo-35mm
Print at 0.2mm layer height. No supports needed. Takes a couple hours to print.
Position PCB inside both halves while aligning the sockets with the holes. Both parts should snap together. Fasten with panel hex nuts.
Print at 0.2mm layer height. No supports needed. Takes a couple hours to print.
Position PCB inside both halves while aligning the sockets with the holes. Both parts should snap together. Fasten with panel hex nuts.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
