Thingiverse
Case for Craftmade Fan Remote
por monkeybiziu
2
Descargas
1
Likes
0
Makes
A significantly slimmer case for a remote control used by Craftmade-brand fans and remote control systems.
Note - the case does require that you remove the large plastic overhangs on either end of the remote and clip the non-used exterior wires.
The case screws together with two M3 machine screws - tap the holes after printing.
Recommend setting support overhangs to 55 degrees - this will keep Cura from adding supports around the outside edges that aren't needed but keep them for the screw holes.
Note - the case does require that you remove the large plastic overhangs on either end of the remote and clip the non-used exterior wires.
The case screws together with two M3 machine screws - tap the holes after printing.
Recommend setting support overhangs to 55 degrees - this will keep Cura from adding supports around the outside edges that aren't needed but keep them for the screw holes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!