Thingiverse
Case for DIY LCD 1602 display device
door Larsanjus
2
Downloads
1
Likes
0
Makes
Widened a bit to allow extra wires etc to fit a better. Also removed supports for arduino and breadboard as they were not needed in my use case.
Original on top, modified below.
If printing again, I'd make the bottom part about 1mm wider and 0.5mm higher to fit more tightly.
Printed on Anycubic PLA with Anycubic Kobra 3 on standard speed/settings.
Original on top, modified below.
If printing again, I'd make the bottom part about 1mm wider and 0.5mm higher to fit more tightly.
Printed on Anycubic PLA with Anycubic Kobra 3 on standard speed/settings.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!