Case for DSO138 mini DIY oscilloscope - H version

A simple DSO138 mini Jyetech DIY oscilloscope case for the H-version, which I recently bought from banggood. This is a remix from https://www.thingiverse.com/thing:3234032 which is for the J-version. (Thank you BETLOG!)

The base is the same as Thing:3234032 (and thus only cut+paste) . The buttons need to be cut as shown in the picture (a design flaw). You may need to file, cut, wire cut in a few places to make it perfect (it's DIY!)...

There are two different cases:

01 case for standard H-version with BNC-connector
02 same as 01 but cutout for serial communication (and direct connection of low-power sensors)


Added a pin near the Via for the BNC connector to directly connect sensors as shown in one of the pictures.

Serial communication works as well, connected only RX,TX and GND.