Case for ESP32 Cam

This is a case for the ESP32 cam.
(see i.e. https://www.fambach.net/esp32-cam-modul/)

It consists of three parts:
1) The main part, where the PCB can be pressed in
2) The bridge, where the camera is seated on
3) The lid, with a hole in the middle for the lens

The lid is screwed onto the main part.
No hole for the power cable is considered, it should be drilled according to specific purposes.

The short cables, which can be seen on the photo, where just for programming purposes. Power and GND line must be soldered to the pins of the PCB top side.