Case for Everything Presence One (EP1)

The Everything Presence One - https://shop.everythingsmart.io/products/everything-presence-one-kit - is an ESP32 based presence sensor, incorporating mm wave sensing technology, a PIR, a temperature/humidity sensor, as well as a light level sensor. It integrates perfectly with Home Assistant via its use of ESPHome.

The board is absolutely perfect, but unfortunately I did not like the standard 3D printed case at all, so in the finest 3D printing tradition I designed my own.

It is intended to be positioned on a table, desk, side table etc, with the board being tilted back by about 10 degrees from the vertical. It makes use of a 90 degree USB-C adapter to route the USB-C power cable out the back. I used https://www.amazon.co.uk/dp/B0B8X6H96S but others should be fine.

The design probably needs a few refinements. In particular it does not make use of both PCB mounting holes. None the less the PCB fits securely and I'm very pleased, now, with my EP1.

Mounting hardware was obtain