Case for Nullbits Tidbit - 6 degree angle

Case for Nullbits Tidbit. Should be able to use your original hardware - including the original back plate if you feel so inclined, but I think a 3d printed plate to allow the LEDs to shine looks best. Designed to work with normal USB cables only - right angle support is planned in v2.

If you don't want to (or cannot) use your original hardware - I've included capture cutouts for m2 nuts in the backplate, so you can use an m2x6 inserted from the top to accomplish the same thing as the original fastening arrangement.

If you use the m2x6 method, you may want to make a little spacer to prevent the pcb and bottom plate from bending into each other as you add more screws and tension - the pinch arrangement applies a ton of force and could very easily bend the PCB beyond spec if you're not careful. I have had success without the spacer, but I was very gentle with the forces I applied - the narrowing top "seat" captures the PCB really well. You don't need to really cranky anything down