Thingiverse
Case for PiCam-HDMI adapter
door Jorx
9
Downloads
3
Likes
0
Makes
I needed an enclosure to house the RasPI-side of the PiCam-HDMI adapter, so I designed this small case. You can superglue/hotglue/acetone it to your RasPI case.
There are no screws etc., however the casing has a very snug fit, so unlikely to open by accident. Add a drop of hotglue or superglue if you want to permanently lock it.
Printed in PLA with 0.16mm layer height and 10% fill.
Word of warning: remove the cables from the adapter before fitting into the case!
There are no screws etc., however the casing has a very snug fit, so unlikely to open by accident. Add a drop of hotglue or superglue if you want to permanently lock it.
Printed in PLA with 0.16mm layer height and 10% fill.
Word of warning: remove the cables from the adapter before fitting into the case!
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!