Thingiverse
Case for Raspberry pi 3 and NAVIO2
8
Downloads
3
Likes
0
Makes
This is not fancy, but it is a workable case for a Raspberry pi 3 + NAVIO 2 board.
For mounting, you can either use the 50mm X 58mm hole pattern of the Raspberry, or the 35mm X 35mm pattern on the `bottom of the box. I left enough opening for adequate airflow.
Use M2.5 X 10mm screws to hold the boards in place. The holes in the bottom have a nut pattern for M3 nuts.
I left a hole for access to the memory card.
Make certain that you also download the cover for this box.
For mounting, you can either use the 50mm X 58mm hole pattern of the Raspberry, or the 35mm X 35mm pattern on the `bottom of the box. I left enough opening for adequate airflow.
Use M2.5 X 10mm screws to hold the boards in place. The holes in the bottom have a nut pattern for M3 nuts.
I left a hole for access to the memory card.
Make certain that you also download the cover for this box.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!