Case for Raspberry Pi 3B+ with 5" touchscreen

I made this case to house my Raspberry Pi 3B+ and 5 inch Touchscreen (XPT2046) that I purchased from Jaycar here in New Zealand. Using it for OctoPrint with TouchUI.


NOTE: This case will not fit the Raspberry Pi 4. The Pi 4 has the Ethernet port and USB in different positions as well as having 2x micro HDMI ports as opposed to a single full size HDMI port.

There are several options for the case. They are:
- Front with Power Button hole, Power & SD Activity LED's
- Front with Power Button hole only
- Front with Power & SD Activity LED's only
- Front with No Power Button or LED's
- Rear with Mount holes, PiCam ribbon slot & 30mm fan
- Rear with PiCam ribbon slot and 30mm fan only

Screen and Pi are held snugly in the case with the pegs on the Rear part of the case. No mounting screws required.

See guides listed in the section below named Various Guides I Used For Setup to assist you in setup.

--------------------------------------------------------------------------