Castle Marble Run

Castle Marble RunBackground: This is my second Marble Run model, with a castle theme 🏰. This time I didn't make it print-in-place. While this makes it more complicated, it also allows for more refinement and the use of different colors. This Marble Run, like the previous one, requires no supports because regular supports create a very uneven bottom surface, and specialized support filament requires flushing (unless you are using an H2D or another 3D Printer with 2 or more nozzles. But this would also waste some time. However, I won't dwell on this, because in any case, I have already made it without supports) Important Notes:The Marble Run (only the track part) need to be printed with the lowest layer height, 0.08mm, otherwise the marbles might stop rolling.After printing, you will also need to slightly clean the stringing off the track for smoother rolling.After assembly, the "elevator" might get a bit stuck, but this problem can be solved by turning it a few times. I