Thingiverse
Cat arch
von MoonmunkiPrint
2
Downloads
0
Likes
0
Makes
Door or wall arch for cats
I mirrored the side piece on Cura and printed them vertically on a raft close together
The arch needs support (I printed it flat on the bed)
Can be scaled in slicer for height and door thickness or altered in Freecad
I used 10% infill and its really strong with a few drops of superglue in the joints
The joining pins required a bit of sanding to fit
I cut the hole in the door and fitted with white silicone.
I mirrored the side piece on Cura and printed them vertically on a raft close together
The arch needs support (I printed it flat on the bed)
Can be scaled in slicer for height and door thickness or altered in Freecad
I used 10% infill and its really strong with a few drops of superglue in the joints
The joining pins required a bit of sanding to fit
I cut the hole in the door and fitted with white silicone.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
