Cat - Boxedables

Cat - Boxedables A commercial license is available on my Patreon: 👉 https://www.patreon.com/c/BOXEDABLES Recommended Slicer Settings: Layer Height: 0.16mm Initial Layer Height: 0.2mm Line Width (Initial Layer): 0.55mm Elephant Foot Compensation: 0.1mm Precise Z Height: Enabled Wall Order: Outer → Inner Wall Loops: 6 Infill Density: 20% Infill Pattern: Gyroid Initial Layer Speed: 25mm/s Infill Speed: 80mm/s Seam Alignment: Aligned or Back (Paint the seam at the back of the model for a clean finish.) Heat Bed Temperature: 50°C (for PLA/PLA+ to prevent elephant foot) Model Size:📏 4x4cm Clone the objects to minimize material waste ⚠ Please note: If you scale the model, you may need to add supports for proper printing. Personal use onlyPurchasing or downloading this file does not give you the right to sell physical prints of this design. Commercial license is available for this design by subscribing to 👉 patreon.com/c/BOXEDABLES Copyright Protected FilesYour purchas