MakerWorld
Hueforge & Lithophane
Zum Modell
Cat in Winter
3
Downloads
8
Likes
1
Makes
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm The Model is 95x160mm in size You may print at higher layer heights below the Min Depth of 0.88mm The Max Depth is 2.2mm and the Actual Depth is 2.3mm Filaments Used:PLA PolyLite Black Transmission Distance: 0.3PLA BambuLab Basic Blue Gray Transmission Distance: 3PLA PolyLite Grey Transmission Distance: 1PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 4 unique filaments Swap Instructions:Start with BlackAt layer #14 (1.2mm) swap to Blue GrayAt layer #19 (1.6mm) swap to GreyAt layer #23 (1.92mm) swap to Jade White for the rest.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
