Cat Key Hanger Improved Remix

I printed this little key holder four times and the slotted portion of the actuator arm kept breaking, so I redesigned the tail and created a new pin that uses the old actuator arm but does not need for you to spread the arm in order to insert the tail. Merely slide the tail into position and insert the pin and you are done. I have printed three of these improved versions and they go together with ease. There might be an issue with filament droop in the hole, but the fix is easy if you experience it, find a small drill bit or hobby knife and remove the droop. The fit is designed to be interference, and because of this, some printers might print the tolerance's a little different, but that is nothing that a drill or file can not fix. I also printed it scaled up to 125%, but the files that I am including are at 100%. I just like the bigger holder. the tail and pin are at 100 percent infill and the remainder are at 15% with organic supports. I used a raft for the pin since it is so small.