Cat Stamp Mold

This is a custom stamp mold. No supports for the base (Stamp Mold). However, the handle I had better luck printing on it's side and using supports. Once the print is complete you take your two part casting putty and press it into the mold. I had good luck applying a little at a time until it was full. Keep in mind you have ~10 minutes until the putty is set. Quicker you pack it in the mold the better. After it's set carefully pull it out of the mold and turn it flip it over and place it back in the mold and screw the handle on. You are ready to Stamp!